how to replace control board in kitchenaid stand mixer ?

Replacing the Control Board in a KitchenAid Stand Mixer

If your KitchenAid stand mixer isn’t functioning properly, it may be time to replace the control board. Replacing the control board in your KitchenAid stand mixer is a fairly simple process that requires minimal tools and materials. This article will provide step-by-step instructions on how to replace the control board in your KitchenAid stand mixer.

Tools and Materials Needed:

-Phillips head screwdriver

-Control board replacement

Step 1: Unplug the mixer from the wall outlet.

Step 2: Remove the bottom cover of the mixer by unscrewing the Phillips head screws located on the bottom of the mixer.

Step 3: Locate the control board inside the mixer. It’s typically located near the back of the upper portion of the mixer.

Step 4: Carefully unplug the two wires leading to the control board.

Step 5: Unscrew the Phillips head screws holding the control board in place.

Step 6: Gently pull out the old control board.

Step 7: Insert the new control board and secure it with the Phillips head screws.

Step 8: Plug the two wires into the control board.

Step 9: Replace the bottom cover of the mixer and secure it with the Phillips head screws.

Step 10: Plug the mixer back into the wall outlet.

Your KitchenAid stand mixer should now be functioning properly with the new control board. If you have any questions or concerns about the process, please consult your owner’s manual or the KitchenAid customer service line for assistance.

Frequently Asked Questions

FAQ 1: How do I remove the control board from a KitchenAid stand mixer?
Answer: To remove the control board from a KitchenAid stand mixer, first unplug the mixer from the power source. Remove the screws attaching the control panel to the mixer body. Carefully disconnect the wiring harness and lift the control board out of the mixer.

FAQ 2: What tools are needed to replace the control board in a KitchenAid stand mixer?
Answer: To replace the control board in a KitchenAid stand mixer, you will need a Phillips-head screwdriver, a flathead screwdriver, and possibly a pair of needle-nose pliers.

FAQ 3: What type of control board does a KitchenAid stand mixer use?
Answer: KitchenAid stand mixers typically use a control board with a digital display, as well as several buttons and/or knobs to adjust speed, time, and other settings.

FAQ 4: How do I install the new control board in a KitchenAid stand mixer?
Answer: To install the new control board in a KitchenAid stand mixer, first plug the mixer into the power source. Carefully connect the wiring harness to the new control board, then attach the board to the mixer body with screws. Finally, test the mixer to make sure it is functioning properly.

FAQ 5: What should I do if the control board on my KitchenAid stand mixer is not functioning properly?
Answer: If the control board on your KitchenAid stand mixer is not functioning properly, first check the wiring connections and make sure they are properly connected. If the connections are secure, you may need to replace the control board.

Similar Posts

Leave a Reply

Your email address will not be published.